As some of you may know, I have diabetes. I have to check my blood sugar a lot. I have a box I've been using for about a year. It contains my 'works' - blood sugar meter, alcohol thingies, pokey thingie, and some extra needles for the pokey thingie. All very technical. I got tired of looking at the black box yesterday. And then I remembered some special fabric I have that's just over-the-top enough to work as a cover.
The lighting is a little off, but you can tell it's my blood spatter fabric. I had some left over from a placemat project and you know I couldn't let it go to waste. It pained me to toss the smidgen I had after covering this box!
Box covering is pretty simple. There are tons of sites that give step by step instructions, so I won't really repeat it all here. Basically, I cut the fabric a bit larger than needed to cover and fold into the inside. I applied Mod Podge to the box and spread out the fabric with my hands, smushing out air pockets as I went. I let the top dry before tackling the sides. When doing the sides, I pretty much worked with the fabric like I would wrapping paper, again using Mod Podge on the box to hold the fabric permanently. I put a little inside for the folded over fabric. The tool I use to hold everything in place while the Mod Podge dries is the lowly plastic clothespin. Wooden ones stick too tight and are hard to get off. I used clothespins all the way around and turned the whole mess over so that the clothespins were the feet of my little blood spatter table until it dried.
It's not beautiful, but it's ironic and unique. And I would guess you could say it's me. Not all scrap stitching has to involve stitching!
No comments:
Post a Comment